Why no throttle response after jump-starting 2011 Ram 2500?

Post a Reply

This topic is empty.

Viewing 10 posts - 1 through 10 (of 10 total)

Author

Posts
May 11, 2025 at 4:02 pm #978 Reply
Dominic
2011 Dodge Ram 2500 was driving till lights where left on, battery died. Jumped it and now zero throttle response, any ideas?? I can unplug the pedal, and it will creep, but other than that nothing. Zero revving in part or neutral as well. Appreciate any advice
May 11, 2025 at 4:03 pm #979 Reply
Chris
Test the battery, if it tests good, then clear codes and go from there, it could just be an electrical fault from the battery draining and not sending enough power around to all the modules.
May 11, 2025 at 4:03 pm #980 Reply
Mason
Unhook battery and touch positive and ground cables together for 5 minutes it’ll reset your computer in the truck.
May 11, 2025 at 4:04 pm #981 Reply
Kody
Maybe check fuses, might have popped one jumping.
May 11, 2025 at 4:04 pm #982 Reply
Ricky
Check your traction control switch.
May 11, 2025 at 4:04 pm #983 Reply
Randy
Charge and test the battery. Alternators are not designed to charge a discharged battery properly. They are there to maintain the battery.
May 11, 2025 at 4:04 pm #984 Reply
Jonathan
If these are anything like chargers, unhook the battery and try again. Seen a bunch of chargers get jumped and then act like it’s in limp mode.
May 11, 2025 at 4:04 pm #985 Reply
Gary
Get that battery charged!
May 11, 2025 at 4:05 pm #986 Reply
Lenard
You’ll have to clear the codes thrown from the battery being low.
May 11, 2025 at 4:05 pm #987 Reply
Tracy
That’s a hard reboot, you can cause more damage doing that, to replace the battery if it’s toast duh.
Author

Posts

Viewing 10 posts - 1 through 10 (of 10 total)

Why no throttle response after jump-starting 2011 Ram 2500?

Related Posts: